previousHome  :  MX5 MIATA PARTS 06-15  :  MIATA EXHAUST  :  RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package 2006-2015

RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package 2006-2015

Item #: GWR-61-1588
RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package  2006-2015
RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package  2006-2015
RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package  2006-2015
RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package  2006-2015
RoadsterSport "SUPER-Q" Stainless Steel PREMIUM ADJUSTABLE Sound MX5 Miata Exhaust - Appearance Package  2006-2015
Click To Enlarge
RoadsterSport "Q" Stainless Steel MX-55 Miata Exhaust - APPEARANCE PACKAGE VERSION 2006-2015

This SPECIAL ORDER version is only for the cars with Appearance package...tips are extended 2.5 inches.


We make THREE exhaust choices for the 2006 and newer Mazda MX-5 Miata, including the RoadsterSport RACE, our best selling RoadsterSport II Duals, and now this duals unit we affectionately call the RoadsterSport Q.

This unit is the most mild...about 10 to 15% louder than stock on an otherwise stock NC...with a deep burble. This unit was designed with the sound absorbing ability to handle future mods including the massive sound gain caused by a header change (either our RoadsterSport header or our Racing Beat header).

Removing the factory header means removing the first catalytic converter which is also a very large resonator. The result of the header change is a massive amount of additional sound down the exhaust tubes. Developing a muffler that could both deliver all the flow of our other RoadsterSport designs yet swallow the sound unleashed by the header was a challenge. The factory muffler does an okay job with the sound from a header change but at the cost of flow and a giving back of much of the hard fought horsepower gains of the header change.

By using smooth mandrel bent 2.5 inch tubing to redirect the flow for a side entrance to the muffler we engineered a sound wave attenuation first chamber to knock down volume level dramatically while maintaining a flow-through design.

Our latest and best dyno results for the header change which are in our forum were obtained with this muffler....all the flow, without all the noise! Yes, simple BOLT ON that bolts to our midpipe, or the factory midpipe, or our Racing Beat midpipes. Weight is 24 pounds.